Weider 8515 Manuale Utente

USER'S MANUALQUESTIONS?As a manufacturer, we are com-mitted to providing completecustomer satisfaction. If you havequestions, or find that there

10CABLE ASSEMBLYAs you assemble the cables and pulleys insteps 14 through 22, please refer to theCABLE DIAGRAM on page 22 of this manual.14. Route the

14CABLE ASSEMBLY22. Attach the Long Cable (23) to the Small ÒUÓ-Bracket (67) with a 1/4Ó Nylon Locknut (2)and a 1/4Ó Flat Washer (10). Do not com-plet

CABLE ASSEMBLY12369581521669291720212210586710575820. Route the Short Cable (58) around the 3 1/2ÓPulley (15) attached to the upper hole in thePress F

IMPORTANT: The assembly is divided into four stages: 1) frameassembly, 2) press and butterfly arm assembly, 3) cable and pulleyassembly, and 4) seat a

5/16" Nylon Locknut (3)Ð191/4" Flat Washer (10)Ð65/16" Flat Washer (8)Ð61" Retainer (69)Ð61/4" x 2 1/2" Screw (43)Ð25/16

REMOVE THIS PART LIST/EXPLODEDDRAWING FROM THE MANUAL!81Note: Ò#Ó indicates a non-illustrated part. Specifications are subject to change without notic

231111885527121544157123214421361603355114192651256463376729923341276541104332165074275062169706970474844454445525339496221067543131741268553216615207

231111885527121544157123214421361603355114192651256463376729923341276541104332165074275062169704844455253394962210671268553216615207483848578156311338

2TABLE OF CONTENTSIMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

31. It is the responsibility of the owner to ensurethat all users of the home gym system areadequately informed of all precautions.2. Read all instruc

4BEFORE YOU BEGINASSEMBLED DIMENSIONS: Height: 74 in.Width: 40 in. Length: 53 in. Foot PlateLow Pulley StationHigh Pulley StationLat BarSeatLeg LeverB

5ASSEMBLY156High Side ofBracketHandles3551Long Side31511411274Before beginning assembly, carefully read thefollowing information and instructions:¥ Pl

6FRAME ASSEMBLY2. Slide the Front Upright (42) onto the 5/16Ó x2 1/2Ó Carriage Bolts (1) in the Base (4).Hand tighten a 5/16Ó Nylon Locknut (3) ontoea

5. Lubricate the pedal axles on the Rear Upright(56). Slide the Left Pedal (79) onto the leftpedal axle, and the Right Pedal (78) onto theright pedal

8FRAME ASSEMBLYARM ASSEMBLY9. Press the Weight Tube Bumper (64) into theend of the Weight Tube (63). Insert theWeight Tube into the stack of Weights (

9ARM ASSEMBLY12. Wet the handle of one Press Arm (46) withsoapy water. Slide a 5Ó Plastic Grip (31) ontothe handle. Press a 1Ó Round Inner Cap (49)int